Dhyana Tango device

This is the reference documentation of the Dhyana Tango device.

you can also find some useful information about the camera models/prerequisite/installation/configuration/compilation in the Dhyana camera plugin section.

Properties

Property name	Mandatory	Default value	Description
internal_trigger_timer	No	999	Soft timer to generate software trigger in millisecond.
temperature_target	No	n/a	To start cooling the detector (C)
trigger_mode	No	STANDARD	Tucam trigger mode: STANDARD GLOBAL SYNCHRONOUS
trigger_edge	No	RISING	To set the trigger level: RISING FALLING

Attributes

Attribute name	RW	Type	Description
global_gain	rw	DevString	Global gain setting on the sensor, HDR, HIGH or LOW
fan_speed	rw	DevUShort	FAN speed for cooling, from 0 to 10
temperature	ro	Devdouble	Temperature of the sensor
temperature_target	rw	Devdouble	Temperature target
firmware_version	ro	DevString	Firmware version
tucam_version	ro	DevString	TUCAM SDK version
trigger_mode	rw	DevString	Tucam trigger mode: STANDARD, GLOBAL or SYNCHRONOUS
trigger_edge	rw	DevString	To set the input trigger level: RISING or FALLING

Commands

Command name	Arg. in	Arg. out	Description
Init	DevVoid	DevVoid	Do not use
State	DevVoid	DevLong	Return the device state
Status	DevVoid	DevString	Return the device state as a string
getAttrStringValueList	DevString: Attribute name	DevVarStringArray: String value list	Return the authorized string value list for a given attribute name